![]() ![]() Now you should be able to connect, and you'll be prompted to generate a new ssh key.Īlternatively, you can use multicast DNS (mDNS) to give your MaaXBoard a name like ' maaxboard.local' which is used instead of the IP address to connect to it. To fix this, simply invalidate the existing ssh key with ssh-keygen: ssh-keygen -R 192.168.1.30 Sometimes, you may even get a message like this when you try to connect via WARNING: REMOTE HOST IDENTIFICATION HAS CHANGED! means that your MaaXBoard is using an IP address that was previously used by a device that was connected to your host computer. If ssh doesn't work, I log into my router and check "attached devices" to find my MaaXBoard's new IP address. If you're like me and have dozens of IOT devices on your desk, your IP address will probably change frequently, as other devices come on and off the network. XBOARD IMAGES HOW TOHow to connect when your IP address changes Once the board is up and running (few minutes) reconnect to the same IP address with SSH: ssh ADDRESS] Save the file with CTRL+O and exit the editor with CTRL+X. If it's still really slow, you can also uncomment the line "GSSAPIAuthentication no" at the top of the file to prevent it from trying to figure out if it should do encrypted authentication on every command. You can write the following instructions into it by typing each line and pressing enter.Ĭtrl_interface=DIR=/var/run/wpa_supplicant XBOARD IMAGES SERIALUse the nano editor to create the file, in your serial console type the command: nano /etc/wpa_supplicant/wpa_nf We will create a wpa_supplicant configuration file with the same credentials. Now we want to allow the board to reconnect on reboot. Once you have split the bands, try deleting and reconnecting to a single band: nmcli con delete nmcli r wifi off nmcli r wifi on The fix is to split the SSIDs apart (most routers have a button to split bands). It's likely that you are on a dual-band or tri-band router that combines 2.5 and 5gHZ into a single SSID. If you see this error:Įrror - secrets were required but not provided. XBOARD IMAGES LICENSESee version 2 and version 3 of the GNU General Public License for more details.NOTE: MaaXBoard works with both 2.5 and 5gHZ WIFI, but not both together in the same SSID. This work is distributed in the hope that it will be useful, but without any warranty without even the implied warranty of merchantability or fitness for a particular purpose. ![]() XBOARD IMAGES SOFTWAREThis work is free software you can redistribute it and/or modify it under the terms of the GNU General Public License as published by the Free Software Foundation either version 2 of the License, or any later version.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |